Basic Information:
Printer Model: FLSUN Q5
MCU / Printerboard: Manta m4p
Host / SBC : CB1
log+cfg+video.zip (6.0 MB)
Hi all, i have this message when the Extruder temprature reaches 230°
or Heater Bed reaches 60° (I can’t use PETG filament).
"Shutdown due to webhooks request
Once the underlying issue is corrected, use the
“FIRMWARE_RESTART” command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
Can not update MCU ‘mcu’ config as it is shutdown
Once the underlying issue is corrected, use the
“FIRMWARE_RESTART” command to reset the firmware, reload the
config, and restart the host software.
Error configuring printer"
In the video contained in the zip file, you can see the behavior.
Klipper and moonraker log + printer.txt (conf) they are also in the zip file.
Someone can help me?
Thanks in advance
Regards