Shutdown due to webhooks request help pls)

General Discussion
1

hello
klippy (4).log (270.9 KB)
moonraker (2).log (36.5 KB)

I am new to 3d printing, and just finishing up my first Voron 2.4 build. I just couldn’t get pass this error here. it is killing me.

Shutdown due to webhooks request
Once the underlying issue is corrected, use the
“FIRMWARE_RESTART” command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown

I tried going through the log and correlating any possible problems, but no luck.
Can someone please point me to the right direction? Much appreciated!

Thanks

2

You may have a look on this thread:

3

I have read this thread It didn’t help me

4

See MCU 'mcu' shutdown: Command request / Shutdown due to webhooks request

This is not an error message, this is an information that you have actively requested a shutdown via the webinterface