Sidewinder x1 need config help

General Discussion
1

Basic Information:

Printer Model: Artillery sidewinder x1
MCU / Printerboard: mks gen L
Host / SBC : Raspberry pi 5
klippy.log
klippy.log (29.9 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

I have board connected to raspberry pi and all axis move. Do not have fan on hotend working or bltouch. Would also like mesh bed leveling and bed screw. Would like help or a copy of working printer.cfg file for my 3d printer.
Sorry if i posted this to wrong site. New to this kind of help.
…

2

Try Clanks-Klipper-Configs/SideWinder X1 BLTouch.cfg at master · Clank50AE/Clanks-Klipper-Configs · GitHub

3

I did try this. I got errors for pinout not correct. I read on reddit someone used the ramps board printer.cfg for sidewinderx1. It worked but no bltouch or bed leveling. Should I try it again? Not sure how to proceed without going backwards.

4

Maybe try Klipper-for-MKS-Boards/MKS Gen l/generic-mks-gen-l-v1.cfg at main · makerbase-mks/Klipper-for-MKS-Boards · GitHub

5

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.