Basic Information: Printer Model: Ender 3V2 MCU / Printerboard: V4.2.2 Chipset GD32F303 klippy.log Hi I’ve just received my Sonic pad and gone through the updates ready to connect to my printer. This issue I have is that I have upgraded my Ender 3v2 with a Direct Drive Sprite Pro and a CR Tou…

Hello @Mazza , I mean. . . Just buy a pi and be done with it. If you don’t want to pay for a pi, buy a btt pi, such as the cb1. I genuinely think that going this route will make it easier on yourself, but do what you think best. Btw I have compiled firmware many times for klipper, and it’s not h…

[image] Blake100: Just buy a pi Recently it’s not just. It is still difficult to get a Pi for a legit price.

Maybe the right wording would have been: “Just do not buy a Sonic Pad” :wink:

Hello, My point exactly @Sineos . I also sort of meant buy a BTT cb1 or something of the sort. Arround 60 bucks for a BTT cb1 and it’s adapter board seems fine to me. Hope this helps, Blake

I have a ender 3 v2 with a sonic pad & sprite pro extruder. I might of found a solution to your problem on reddit. you need to edit the printer.cfg file on the sonic pad with these updates (they worked for me with a bit of fine tuning) [stepper_x] step_pin: PC2 dir_pin: PB9 enable_pin: !PC3 micros…

Hello @p666buc ! Please: Either upload your code as file or put it between code braces: [Format] The way you did it is unfortunate because the formatting gets lost or gets weird and is of no use for other users.

Thank you for the advise EddyMI3D. I think i’ve done it correct this time. im new to 3D printing & this is my 1st time posting on a forum.

This is what i used to get my print up and going after reading every ones post… 4.2.2 board Sprite Pro hot end Home and bed probe position should be center. Should be no boundary issues for mesh Filament sensor was added Using a Sonic Pad # !Ender-3 V2 ABL # printer_size: 220x220x250 # versio…

I’m using this custom gcode, but it’s giving me an end of filament error, what should I do because I’m not using a filament sensor on my ender 3v2

Hello @sandroforms ! Maybe you delete the filament_sensor section?

Sonic Pad to Ender 3v2 with Sprite Pro and CR Touch

General Discussion

EddyMI3D February 6, 2024, 6:55am 20

Topic		Replies	Views
Ender 3 V2 + CR-Touch Configs	1	34857	October 10, 2024
How to fix CR touch with Sprite extruder on Ender 3 v2 General Discussion	4	5284	April 4, 2024
Ender 5 and Creality Sonic Pad General Discussion	22	5129	February 23, 2024
Creality Ender-3 Pro Custom with Creality 2.2 Silent Board + second Z motor and BLtouch Configs	20	4246	March 13, 2025
Ender 3 max neo w/ creality V4.2.7, and sonic pad General Discussion	5	1195	March 18, 2024

Sonic Pad to Ender 3v2 with Sprite Pro and CR Touch

Related topics