I have a sovol sv08 max… Has anyone permanently wired in/installed an ADXL345 for onboard toolhead resonance frequency measurement? If so, how did you get it working in klipper / orca slicer?
maybe some literature about the setup to start.
The Max has an accelerometer soldered to the toolhead board.
[lis2dw]
cs_pin: extra_mcu:PB12
spi_software_sclk_pin: extra_mcu:PB13
spi_software_mosi_pin: extra_mcu:PB15
spi_software_miso_pin: extra_mcu:PB14
axes_map: x,z,y
Is there some reason you need an ADXL345?