SYNC_EXTRUDER_MOTION doesn't sync PA

General Discussion
1

Basic Information:

Printer Model: CUSTOM 2 HEAD
MCU / Printerboard: MANTA M8P
Host / SBC: CB2
klippy.log:

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

When I run this command ( SYNC_EXTRUDER_MOTION EXTRUDER=extruder1 MOTION_QUEUE=extruder) it syncs the extruder motor motion but it doesn’t sync the pressure advance feature. I’ve read back through the articles online but still can’t figure out how to get the PA to sync. I don’t really need independent control, I just want my second print head to sync to the PA called for on my first print head. Anyone figure this out?
…

2

Hello @Therealbob !

grafik
grafik812×318 15.9 KB

Please attach it to your next post.

1 Like
3

Here’s my Klippy Log, Thank you.
klippy.log (3.4 MB)

4

You need to do this explicitly with

SET_PRESSURE_ADVANCE ADVANCE=... EXTRUDER=...