Basic Information:
Printer Model: Voron 2.4
MCU / Printerboard: Fysetc S6 V2.1
Host / SBC: Orange Pi 3 LTS
klippy.log (181.2 KB)
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Since Klipper Commit 2a1027c i have this error when i start my printer:
Klipper reports: SHUTDOWN
Unhandled exception during run
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
Klipper Commit f33c76d does not have this error.
I have a usb cartographer probe.
Is there something i have to change it the config file, when using klipper newer then commit f33c76d?