Voron Trident extruder motor stalling at specific Y-axis

General Discussion
1

Basic Information:

Printer Model: Voron trident
MCU / Printerboard: MKS SKIPR
Host / SBC: fluidd
klippy.log

Describe your issue:

*** The extruder is working well if the Y axis is bigger than 160 , but it starts making clicking sound inside whenever the Y is lower than 160, and I tried to move the Y by hand or throw the webUI both got the same issue.

I uploaded video of my trident under.

My trident:
size: 300, 300, 300
board: mks skipr
system: armbian with fluidd, klipper, mainsail, moonraker, z is using TAP

I’m too new to know where I can find the fixing for this , plz if there is anyone know this, help me with, thank you so much!
printer.cfg (18.8 KB)
https://www.youtube.com/watch?v=NyvHo5rAZJM

2

Hello @g1mi !

This could well be a mechanical issue.

Have you already asked in the Voron forums?

3

not yet, ġonna do that, thx!

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.