When BED MESH is active?

General Discussion
1

Basic Information:

Printer Model: RatRig Vcore 3.1
MCU / Printerboard: Octopus Pro
Host / SBC rPi 4
klippy.log (Not necessary)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…

Not an issue…

Hi,

In my macro to start printing, I do the MESH BED before printing…
which is the one I use when I start printing.
But there are points where I have doubts if when printing the print head follows the bed…

To do this I want to check the MESH BED at various points, moving the head to different X and Y coordinates and checking that the height in Z is correct.

Those points would be where the graph tells me that there is more variation in Z…

The print head, if the MESH BED is loaded:

  • Does it use it in movements that are NOT printing? (The movements that are made, in my case, by the Fluidd interface)

or

  • Is it only used in movements during printing?
2

The Z-compensation is active on each move as soon as a mesh is actively loaded.
Just watch your Z-steppers when jogging around the print-head.

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.