Basic Information:
Printer Model: Ender 3
MCU / Printerboard: 4.2.7
Host / SBC Rpi4
klippy.log
klippy.zip (17.1 KB)
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Moving the z axis works in one direction but not in the other. I can reverse the pin in the config file and it does the same thing just in the other direction.
…
