All motors not working

General Discussion
1

Basic Information:

Printer Model: Creality Cr-10S
MCU / Printerboard: Creality V2.1
Host / SBC
klippy.log
logs-20240830-023553.zip (44.9 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Basically everything was working perfectly and after i rebooted printer, none of the motors were wroking, i could still heat bed and extruder but none of the motors are moving, they are becoming softer(i can move them easier) when i turn on the printer so that means all connections are fine. I checked all the cables, checked the PSU, everything is working as normal. The printer.cfg has not been edited before it stopped working? ANY help would be deeply appreciated!

2

Greetings! I see that you had a very similar problem to mine. Did you manage to solve it?

4

Obviously not, else this thread would be marked as solved.

5

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.