BTT SKR V2 considerations

General Discussion
1

Basic Information:

Printer Model: Anycubic Mega Pro
MCU / Printerboard: SKR V2
Host / SBC Raspberry PI 3

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…I have an BTT SKR V2 board I’m thinking about upgrading my Mega Pro with it. My question is if there are any special considerations to take into account to run klipper on the SKR?
I am currently running Klipper on the trigorilla so have some familiarity with it.
Thank you.

2

This is a well known board. There should be no surprises…at least not major ones…well, the usual stuff…maybe only small fires…should work :wink:

See klipper/config/generic-bigtreetech-skr-2.cfg at master · Klipper3d/klipper · GitHub

3

Good to know. Thanks for your reply.

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.