Changing Z after bed mesh

General Discussion
1

Basic Information:

Printer Model:
MCU / Printerboard:
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue: If the bed mesh is calibrated, will the mesh remain valid if the Z reference height is changed?

Significance: I read the bed mesh data with a dockable probe attached. I then detach the probe and determine the Z reference by probing with the nozzle over a single position on the bed.
…
klippy.log (1.3 MB)

2

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.