CR-M4 imidiately stops after heating extruder after successful print

General Discussion
1

Basic Information:

Printer Model: Creality CR-M4
MCU / Printerboard: STM32F401
(to run resonance calibration I use linux as board)
Host / SBC Creality Sonicpad with Debian
klippy.log
klippy (2).zip (5.1 MB)

Screenshot_4
Screenshot_4897×561 45.9 KB

My printer immidiately stops after start heating, and only showing mcu error like this.
does this mean that is it simply a connection error? It did run few prints before this, I made sure that thermistor is connected correctly and there are no loose cables.

I tried to search by my best, including similar model in construction(Ender3 S1) but I could get no better result.

2

See Timeout with MCU / Lost communication with MCU

3

okay, I looked into that last time. Thanks for reminding me.
In the past the issue was USB cable, so I gotta adjust currents in cfg this time.
or I need better power supply