CR10S V2.2 board

[EddyMI3D]

@dasaint80

But after I power cycle the board the screen goes blank.

That is normal. The host (RasPi etc) has to establish a new connection to the client (printer)

For further information:

Klipper Architecture / Ecosystem

Klipper Architecture / Ecosystem Calling Klipper a 3D printer firmware is not complete to its full extent. In fact it is a 3D printing application with an associated ecosystem. The following overview shows how the different aspects interact. Only the red boxes is Klipper in its original sense, the other boxes are independent products forming the entire ecosystem. [Untitled Diagram.drawio] Klipper Host The core of the Klipper environment Typically running on a Single Board Computer (SBC), …