Basic Information:
Printer Model: Sidewinder X1
MCU / Printerboard: SKR 1.4 TURBO
Host / SBC: Raspberry Pi3
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
…
Here’s the translation in clear, natural English:
Good evening guys. I’m having some trouble setting up Klipper on my Sidewinder X1 with an SKR 1.4 Turbo, especially with the stock endstops. When I run homing, it seems like the pins are correct because neither the carriage nor the bed crash anymore (which they did before I found the right pins), but when I test the endstops with query_endstops, they always stay ‘open’, both when they’re free and when I block them. Since I’m also getting some layer shifting, I’m starting to think the endstops might actually be the cause.