Endstop z still triggered after retract on SKR Mini E3 v3

General Discussion
1

Basic Information:

Printer Model: Ender 3 Pro
MCU / Printerboard: SKR Mini E3 V3 ( brand new )
klippy.log
logs-20231223-113432.zip (71.7 KB)

Describe your issue:

Santa brought some parts upgrades for the old Ender 3 Pro, which includes the new SKR Mini E3 V3.

I also have a BLTouch ( had it for ages ) and it worked under Klipper and on the v.4.2.7 main board that i had in it previous.

When I attempt a G28, the process fails with Endstop z still triggered after restart. The probe/needle does not extend or retract and the red light stays ago on the device. I found a BLTouch config for the SKR Mini E3 v3 and have been using that.

I do think i have the physical plug in correctly, i could only really get it to fit one way.

Is this a wrong pinout? wrong configuration? Does anyone have a working config that they wouldn’t mind sharing?

Thank you for any help.

2

v3.0 or v3.0.1? They have different pinouts.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.