Hi, when try to move motors, homing, Klipper shutodwn, and shows this error… I have try, to homing only in X and Y, and the same… Unable to read tmc uart ‘stepper_z’ register IFCNT The better, i have not driver , no motor in Z slots of OCTOPUS PRO The board is an Octopus pro and the drivers a…

Please see the link above. This kind of errors always indicate that something is wrong electrically. The drivers itself are reporting these errors and Klipper just reacts upon them. [image] Peurif: When the error refers to ‘stepper_z’, does it refer to a specific driver that is in position 6 of…

Error message at homing

General Discussion

Sineos March 16, 2022, 10:19am 2

Please attach your klippy.log file here

Also refer to various existing topics, in particular TMC 'extruder' reports error: GSTAT: 00000001 reset=1(reset - #39 by Sineos

Topic		Replies	Views
Problems setting up sensorless homing General Discussion	1	113	March 19, 2024
Intermittent TMC driver crash - Unable to read tmc uart registers General Discussion	19	2683	November 5, 2023
Homing failed multi Z General Discussion	3	159	November 20, 2023
TMC2208: periodically gets errors while homing General Discussion	9	1327	June 11, 2021
Error message: Unable to read tmc uart 'stepper_z' register IFCNT General Discussion	5	451	January 17, 2024

Error message at homing

Related Topics