Help with config: Ender 3 (v1) Creality 4.2.7 Stock extruder

General Discussion
1

Basic Information:

Printer Model: Ender 3 V1
MCU / Printerboard: Creality 4.2.7
Host / SBC BTT Pi V 1.2
klippy.log
logs-20241027-190742.zip (860 Bytes)

Describe your issue:

…

Hi All!

First time Klipper user here recently got into 3D printing and loving it.

From what I have read I should use a generic 4.2.7 example config but I’m a bit nervous about using that and configuring it to suit my ender 3 (v1) which I upgraded to a 4.2.7 board (for noise reasons).

Does anyone have a config that would suit my set up that they could share (or walk me through the necessary changes)?

My set up is with stock bowden extruder and hotend.

So far I have been following this guide: https://youtu.be/xBpkeKKwu48?si=fcxY4I1U84Tt2Ifd and I’m up to the 8 minute mark where I’ve flashed the SD card and logged in and made the processor selection and firmware.bin

2

Welcome

That’s great. Klipper is fantastic
Tell me more about your hardware, where did you install Klipper?
The example files are a great place to start. At the beginning of the file there is information on how to correctly configure the hardware. Send me screenshots of where you are in the settings.