Help with Klipper on Anycubic Mega Zero V1?

General Discussion
1

Basic Information:

Printer Model: Anycubic Mega Zero
MCU / Printerboard: ATMEGA1284P – MEGA ZERO V0.0.3
klippy.log

Hi Im trying to install klipper to my Mega Zero, Im using a Raspberry Pi 3B+ with Mainsail OS 1.2.1, I succesfully install the OS make clean and when i make the firmware for the printer i get klipper.elf.hex instead of klipper.bin.
researching a bit i found that that problem is because i need to flash a preconfig to it but i wasnt able to find some for this printer.

Can someone bring light to my i really want to try it because in 2 years with this printer i havent been able to print more than 2 or 3 times, and maybe with this update and the new upgrades (heated bed and auto level ) maybe i can print succesfully the boat

Thanks for your time and i hope someone can help me :slight_smile:

2

You can check the config for the melzi board and flashing directions from here
klipper/config/generic-melzi.cfg at master · Klipper3d/klipper (github.com)
My first attempt a couple years ago worked with this as a foundation.

3

Thank you so much Im gonna try it.
Maybe I’m smart enough to do it :joy: