This topic was created to add support for bed mesh for idex printing.
Idea is: if the table is controlled by two or four motors, allowing it to tilt, then we can lift it not only entirely up or down, but also each side individually. Since the bed mesh is not symmetricall, it would be useful if, when printing in idex modes, each side moved up/down independently, depending on the irregularities on the right and left. If you can tell me which scripts are responsible for the logic of bed mesh, I can add this algorithm to them, but now I’m at a dead end.
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.