Impossible de configurer le zoffset

General Discussion
1

Basic Information:

Printer Model: endewire
MCU / Printerboard: btt skr pico
Host / SBC pi4
klippy.log (1.1 MB)
klippy.log
hi
I just finished installing my enderewire but a strange thing happens
when I do a zoffset the machine responds correctly, I save the parameters but as soon as I do a test again everything comes back to the basics
I tried via klipperscreen and the console but the problem persists
I’ve been on this for several days and I don’t see the solution, I’m depressed

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…

2

Hello @turlututumaske !

What command did you use?

I assume this is your probe

[scanner]
3

I used save_config and in klipperscreen the save settings button After all klipper restart
yes scanner is for the cartographer (like bacon)

4

To save the z_offset you have to use

  • Z_OFFSET_APPLY_PROBE when you have a probe
  • Z_OFFSET_APPLY_ENDSTOP when you have a endstop

before the SAVE_CONFIG

5

yes I also tried by setting the nozzle to zero then doing the zoffset and once finding the right one
I did
Z_OFFSET_APPLY_PROBE
SAVE_CONFIG