Installing BTT pitft 43 v2.1

Frontends KlipperScreen
1

Basic Information:

Printer Model: voron 2.4r2
MCU / Printerboard:Octopus v1.1
Host / SBC rpi4b
klippy.log

Hi all, can someone advise on installing a BTT piTFT 42. I’ve had an older pi7” screen fitted which used a ribbon and power supply. I’ve tried plugging in the “piftf “ using the ribbon as there doesn’t seem to be a power input on the back? But just a black screen! Is there any ‘drivers’ etc to install?
Any advice would be greatly appreciated

Describe your issue:

…

2

I assume you want to install Klipper Screen?

3

Hi, I have Klipperscreen installed and it was working correctly with the previous installed screen

4

IMG_0132
IMG_01321320×2868 213 KB

This is shown on the main screen

5

You may follow this video https://www.youtube.com/watch?v=qBH296kQ_OE

Probably not your language, but you can use “CC” in your language.
cc

Good luck, hcet14

6

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.