Issue: MCU 'mcu' shutdown: Rescheduled timer in the past

General Discussion
1

Basic Information:

Printer Model:Tronxy
MCU / Printerboard: BTT tango v1.0
Host / SBC Raspberry Pi

klippy Nov17.log.zip (1.1 MB)
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

My printer began throwing this error. Ive read through a lot of posts on this. I”ve tried reducing my microsteps, i’ve tried reducing microsteps, i’ve tried slowing my print down to 25% of normal speed. I still get the error exactly at the same spot every time. It will lay down the first layer, then throw the error as it moves to start the spiral vase going up.

I’ve been using this printer for years, I’ve been printing this exact part for weeks now. This issue came up and I can’t fix it.

I’ve uplaoded the offending gcode in case that helps.

0StarPieceRounded.gcode (1.0 MB)

…

2

somebody close this. I sliced a different part and sent it to the printer it all worked. Then I re-sliced this part it printed. Now i’ve done this about five times, but doing it after I posted this somehow made the difference.

1 Like