Klipper ERROR Lines in [bed_mesh_default]

General Discussion
1

Basic Information:

Printer Model: Ender 3
MCU / Printerboard: BTT E3 RRF
Host / SBC: Raspberry Pi 4b
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Hi all

I have errors coming up when I start Mainsail on my Pi. The errors appear to be coming from the “DO NOT EDIT” section of the printer.cfg under the [bed_mesh_default].

The Ender 3 is second hand and has the klipper firmware flashed onto the BTT mainboard by the previous owner. I have used the text of his printer.cfg and modified the formatting and file path to eliminate other errors. As soon as I fixed those errors, the new ones regarding the bed_mesh_default came up.

These have me stumped.

The printer has a BL Touch installed.

When I turn the printer on there is no movement at all, but I do see an led lit in the BL Touch probe.

I am new the 3d printing and seem to have jumped in at the deep end. But any assistance greatly appreciated.

Thank you.

klippy.log (15.6 KB)

2

Hello @DesP and welcome to the forum!

In this case, please attach the complete config file to your next post.

3

You could try this configuration:

Note- No [probe] section in this. You’d have to add it once you prove it will load.

Keep plugging along, it gets easier.

4

Thanks for the comments Cardoc and EddyMI3D

I have managed to get rid of the errors with some help and now looking at calibrating the BL Touch before trying my first print.

Regards

DesP