Klipper freezes on R Pi4B when running bed mesh with new profile

General Discussion
1

Basic Information:R Pi Klipper freezes

Printer Model: Ender 3 s1 pro
MCU / Printerboard:R Pi4B
klippy.log
klippy.zip (1.4 MB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…
Just wondering if anyone else has run into this issue? I have an R Pi4B running Mainsail/Klipper and when I run a bed mesh with new profile, it completes, I accept the new mesh and then it freezes with the grid displaying the offsets. If I use “default” for the file, it works perfectly.

Not a big deal but would be nice to save new profile names with the mesh.

Cheers

2

grafik
grafik1027×60 10.4 KB

2 Likes
3

@Kilohertz

Are you sure the issue is within the klippy.log?

I can’t find anything than just two print runs.

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.