Klipper shuts down when filament not detected

Hello. Klipper goes into a shutdown state when the filament is not detected by the filament sensor. I can not connect to the printer after FIRMWARE_RESTART unless I put the filament back in or unplug the sensor.

Printer: Ender 3 Pro (Creality 4.2.2 Board) with OctoKlipper
Klipper Log (last two restarts): klippy.log

Thanks in advance.

Please post your klippy.log

I swapped the red and white wires in the filament sensor connector and that solved my problem.

1 Like