BIGTREETECH SKR Mini E3 V2.0 Octoprint Ender 3v2 Firmware version: v0.10.0-278-g7c964e5f klippy.log (1.7 MB) it stopps during print and said mcu failure etc after restart it shows bed temp over 700C if i switch the termistor with the one from hotend under octoprint the value does not change p…

This sounds like a broken cable for the temperature sensor. Can you check if it is ok?

I have test with other thermistor and also i have a view new ones from hotend- sadly same problem

Typically this error is caused by a hardware defect: Thermistor itself Cable Connector Port on the board Connect the problematic thermistor to another temperature port on your board. If it then works, then the port on your board has died.

Hi, as I said if I switch the thermistor from hotendport to bed and vice versa- the bed temperature under octoprint stays on bed temp ~700c so i don’t think it’s the thermistor itself :confused: Could I check anything in port itself ? Or you think it’s a board defect than will i order a new one

Well, if: you already tried restarting the klipper service / rebooting your RPi / cutting power to your entire setup it worked before it suddenly stopped working you have not modified your config (PC3 seems the right pin) you have verified cable and thermistor with the other port then the chances…

Yep all tried - than the board ist crap - I will order the V3 - thanks for your support

Another thing to try might be to connect the thermistor to a different port on the board and change the config to the other port. This of course requires to have another port available. That way you can exclude that you miss something elsewhere…

Was there any work done to improve logging details of these messages? Currently it is still a pain to determine which thermistor is failing, I was looking at the logs and still can’t determine which one is causing the problem.

[image] Nandox7: Was there any work done to improve logging details of these messages? Nope. See Advanced Trouble-Shooting / Graphing Klipper This might help in diagnosing

MCU 'mcu' shutdown: ADC out of range

General Discussion

Sineos March 10, 2023, 6:41pm 10

Nope.

See Advanced Trouble-Shooting / Graphing Klipper
This might help in diagnosing

Topic		Replies	Views
Faulty thermistor/MCU on v4.2.7 General Discussion	19	396	September 5, 2025
Klipper state: Disconnect, Ready, Shutdown General Discussion	2	1089	March 6, 2024
Mcu keeps shutting down saying temps out General Discussion	6	475	November 17, 2024
MCU 'mcu' shutdown: ADC out of range with fresh NTC 100K General Discussion	2	771	October 24, 2023
New Build - MCU 'mcu' shutdown: ADC out of range General Discussion	5	697	July 16, 2024

MCU 'mcu' shutdown: ADC out of range

Related topics