Basic Information:
Printer Model: Franken-Ender
MCU / Printerboard:Manta M8p
Host / SBC: CB2
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Hey, I am trying my first clipper setup and I am encountering this error:
klippy-2.log (521.7 KB)
and it is alternating between another error:
klippy(3).log (911.3 KB)
From the file it tries to update the old mcu unit, but cannot open it? but I already updated with the stm-version for mcu. The system also runs on the memory of the cb2 not sd-card, if it helps
I hope someone can help with a workaround,
Best regards