Modded Ender 3 Pro + CR Touch

General Discussion
1

I have an Ender 3 Pro that is expanded to 400x400x500 mm. It has a sprite extruder, a CR touch, and it is running on a BTT SKR Mini E3 V3.0 and a Raspberry Pi running Klipper Mainsail. I am struggling to figure out the firmware and configs that I need for my CR touch to work with this setup. I dont have much experience with the Config files as I used OctoPrint for quite some time and just recently switched over to Klipper. From what I understand, the most complex thing about my scenario is that I cant use premade CR touch configs because my build volume is different. Any help you can offer will be greatly appriciated.

klippy.log (535.8 KB)

2

Hello @OhCuando !

The Configs sub forum is for finished configs only.

Help requests have to go to General Discussions.

I’ll move it for you.

Please provide the following information:

Basic Information:

Printer Model:
MCU / Printerboard:
klippy.log

Fill out above information and in all cases attach your klippy.log file. Pasting your printer.cfg is not needed
Be sure to check our Knowledge Base and in particular this and this post