Basic Information: Printer Model: Ender 5 Pro MCU / Printerboard: BTT SKR mini e3 v3 klippy.log Describe your issue: Hey! im running some tests with small nozzle and low print speeds, for just good quality, sharp corners etc. And that works good until i need retract. Im using firmware retract…

Relative values refer to Default speed. [grafik] It makes it more easy when you want to change all speeds.

Thats just speed of the extruder not actually the printheads moves after retracted :man_shrugging:

[image] BultiZ: And with that low non-print move speed, stringing is almost a certain… So how can i move for 100 mm/s while retracted and 30 mm/s whilst printing? Sorry, apparently I misunderstood your intention. What you are searching for, is commonly referred to as “travel speed” and not pa…

So how would i set this up? Without making it messy for klipper? Im using super slicer. Should i set print speeds to 20% or 20mm/s and travel speed 100% or 100mm/s in slicer And klipper velocity to 100mm/s Does it matter if using mm/s or % speeds in slicer?

[image] BultiZ: travel speed 100% You can’t set travel speed to percentage in SuperSlicer: [grafik] mm/s is absolute % is relative to a certain value

Yeah you are right! So absolute numbers for travel speed and then use relative for print moves so klipper can do its magic with input shaping or whatever that uses it?

Ah makes sense! Will do some tests later! Thx!

Non-print moves?

General Discussion

Blackstump July 2, 2023, 3:27am 4

extruder only moves

Topic		Replies	Views
Firmware retraction is slow moving, slicer or klipper problem? General Discussion	3	3054	June 13, 2023
Klipper Installed now what about printing real models General Discussion	3	1452	October 9, 2022
Extruder acceleration on Ender 3 V2 General Discussion	4	18267	July 13, 2021
Maximizing Speed test from TeachingTech General Discussion	5	6069	April 1, 2023
What are the steps for faster printing? General Discussion	14	843	May 20, 2025

Non-print moves?

Related topics