hi everyone
bought my sv07 a few months ago and everything has been fine until a few weeks ago when i was getting lots of notifications about updating klipper and having to reboot after eery start up. it all came crashing down when i did a print and when it had finished the probe came down on top of it and crushed the print.
i have since updating all the firmware but now i am stuck with
option “z_offset” in section “probe” must be specified.
i have searched around and all i can find are answers for bltouch but no sovol. i have even tried some of these but nothing is working.
has anyone any ideas?
please talk to me like a child as i have no idea what all the technical jargon means. im very new to all this.
have attached klippy log and my probe settings
Printer Model: sovol svo7
klippy (4).log (79.8 KB)
config-20240700-151606.zip (1.1 KB)