Possible frozen hot end fix

[Sineos]

@gene1934

Extruder way out of calibration at default 33.xxxx
I just started another relative small 2 hour print after setting the rotation_distance to 10.5 and then dialing octoprint down to 85% which is looking decent.

Oh, come on Gene. Please not back to messing around. How to properly calibrate your extruder, we have discussed here: Extrusion diff between part printed withe Marlin, and one printed by klipper - #4 by Sineos

@gene1934

I’d like to pull back 150mm at job end, and restore 151mm at job start, but klipper does not allow that.

The idea is to end a job with enough retraction to get the hot end of the filament pulled 30mm up out of the heat break into cooler bowden tube quickly, then an additional 18mm slowly to keep it from sticking to the innards of the tube.

Not at all needed. Just do a small retraction at print’s end (2-5mm) and be happy.

@gene1934

Does anyone think this might be helpful with a constantly frozen hotend?

What the hell is a frozen hotend?