Printer_data/config/cx_gmcro.cfg' does not exist

General Discussion
1

Basic Information:

Printer Model: Ender 3 Max
MCU / Printerboard: 4.2.2
klippy.log

Hello,

I have installed Klipper on a Pi 3 and getting this error: printer_data/config/cx_gmcro.cfg’ does not exist and can not find any information about it.

thank you
best regards

Amir
klippy-2.log (205.6 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…

2

Somewhere in your config you have an [include cx_gmcro.cfg] which tried to include a file that apparently does not exist.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.