Problem (Makefile: 73: out/klipper.elf) erro 1

General Discussion
1

Basic Information:

Printer Model: Ender 3 v2
MCU / Printerboard: 4.2.2
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue: Of course, here’s an improved version for better clarity on forums:

I’ve been attempting to install Klipper on an older computer, following various online tutorials. The instructions typically advise installing Ubuntu OS (I chose 22.04) and then proceeding with the installation steps using KIAUH. However, I consistently encounter an issue when attempting to create the .bin file.

The error message I receive is “collect2: error: ld returned 1 exit status make: *** [Makefile:73: out/klipper.elf] Error 1”.

Any insights or suggestions on how to troubleshoot and resolve this problem would be greatly appreciated.

2

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.