Qgl bug after klipper update

General Discussion
1

Basic Information:

Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…quad gantry leveling buged after updating klipper before that i was using qgl perfectly now it wll twist my gantry i sure eveything working correctly and motor places is correct because i was using that before update

2

Hello @Dave666 and welcome to the forum!

Pease attach the requested klippy.log to your next post.

3

klippy.log (89.4 KB)tnx

4

Your log is very short and does not contain any QGL errors.

It does ahow your BLtouch tossed a unknown status error. Also it read your bed as very tilted.

Check your probe repeatability several places on your bed:

If it passes then do 3 or 4 QGL passes then upload the full klippy.log

5

klippy (2).log (573.4 KB)

sry about late but the problem still there after new update