QIDI x max 3 tool head

General Discussion
1

Basic Information:

Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

I’m trying to figure out how to connect QIDI x-max-3 tool head to octopus board … runs 24v through usb cable but I am unsure what the communication is … if I can connect it through CAN or if I cut the cable and run the power to 24v and then signal wires to witch ?
…

2

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.