SKR Pro 1.1 WiFi

General Discussion
1

Good morning/evening All!

French man here, living in Egypt, new to Klipper/3D printing!

I am building a Hypercube Evo from scratch, here in Egypt (sourcing material is a pain in the *$%)!
Machine is ready, managed to get a SKR Pro 1.1 + TMC2209, I want to run it through WiFi from a Raspberry Pi 4 (already installed Klipper and Mainsail on the Pi using KIAUH), after a lot of struggles…managed to flash the ESP 01S destined to go on the SKR.
My questions : What are the next steps ? shall I flash the SKR? if yes, can it be done via WiFi ? or SD Card?

Thanks for your help!

PS: This is my first try at Klipper/3D printing, previous experience being with Marlin to run a MPCNC…so I am a bit lost with this new adventure!

2

Klipper does not support (nor is it needed) WIFI modules on the MCUs. Controlling and managing Klipper is done from the host, i.e. your RPi4, and the available web-interfaces.

1 Like
3

Thanks for that! as you say, there is no need, as I have the raspi connected to it!
Cheers!