Basic Information: Printer Model: Lotmaxx Shark V2 MCU / Printerboard: STM32F407 Host / SBC klippy.log Describe your issue: As the title implies, I have recently acquired a Lotmaxx Shark V2. I’m new to Klipper as I’ve just converted my CR10 Smart to Klipper. I’ve seen online, many peopl…

Basically it is not that hard. Take the config of something vaguely similar, e.g. klipper/config/generic-mks-rumba32-v1.0.cfg at master · Klipper3d/klipper · GitHub , and replace the pin definitions with yours.

Thanks. I’ll try it. I noticed it has an extruder setting, then below it are extruder 1 and 2, both commented out. Do I do the same, or “define” both extruders and leave them uncommented? (not sure what the correct term is, but don’t put a hash tag in front of the line).

[image] Hammer3091: I noticed it has an extruder setting, then below it are extruder 1 and 2, both commented out. Well, if you have more than one extruder then you might want to use it. Your goal is to reflect your physical hardware with the appropriate setting blocks.

Any chance you could share the pinout and your journey? I am considering it on my Shark v2, It is fully calibrated and printing beautifully but slowly.

Give me a couple of days. I’ll dig everything out. I sold the printer, so i didnt pursue any further.

Below is the pinout I have for the Shark. I do not know what bootloader to load, but the chip is correct. If you scroll down, I made a note where I stopped. I don’t know if the bottom part will work or not. Again, I haven’t tested this as I have sold my shark. Please keep me posted on your succ…

@Hammer3091 : Either upload your code as a file: [Upload] Or at least use the Preformatted Text feature of the forum editor for your code: [Format] The way you did makes it useless.

I wouldn’t say its useless. You can always type it in by hand into your printer config file like I’ve been doing. However, in the interest of speeding things along, I don’t have the options you posted. I am very new to 95% of this (except the internet. I predate the internet), so if you could te…

It’s useless because There are missing spaces and other characters are used to re-format the text. That way. It should look like this: # This file contains common pin mappings for Lotmaxx Shark V2. To use # this config, the firmware should be compiled for the STMicroelectronics STM32, # Processor…

I don’t have those options on a computer. I only have those options if i private message someone. Where are those options on a computer?

Trying to create a config file from scratch

General Discussion

Sineos January 17, 2025, 11:04am 12

See How-To Ask for Help (directly below the screenshot)

Topic		Replies	Views
Drucker gebaut aber bei der config stehe ich an General Discussion	10	871	May 10, 2022
Config file help General Discussion	1	512	September 15, 2023
Printer.cfg creation General Discussion	4	2169	June 21, 2023
Sanity Check** I need HELP! General Discussion	2	1653	June 9, 2022
Klipper working printer.cfg file for sidewinder x1 witn mks gen L board General Discussion	4	292	August 17, 2024

Trying to create a config file from scratch

Related topics