Basic Information: Printer Model: tronxy x5sa MCU / Printerboard:manta m8p klippy (4).log (366.5 KB) <a name="p-24355-describe-your-issue-ok-me-again-i-installed-a-bl-touch-clone-3d-touch-i-got-the-printer-to-home-the-command-bltouch_debug-commandpin_downup-work-but-it-still-registers-as-open-when-up-i-did-not-understand-where-2" class="anchor" href="#p-24355-describe-your-issue-ok-me-again-i-installed-a-bl-touch-clone-3d-touch-i-got-the-printer-to-home-the-command-bltouch_debug-commandpin_downup-work-but-it-still-registers-as-open-when-up-i-did-not-understand-where-2" aria-label="Heading link"> Describe your issue: ok me again. I installed a bl touch clone “3d touch” I got the printer to home the command BLTOUCH_DEBUG COMMAND=pin_down/up work but it still registers as open when up.…

Do you see in your printer.cfg file that all it has are 2 included files? This is not correct. You need to delete printer.cfg and rename generic-bigtreetech-manta-m8p-V1_0.cfg to printer.cfg. Then at the top of that new printer.cfg file add: [include mainsail.cfg]

when I try to set the z offset in the dashboard I get"SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value"

[image] SAVE_CONFIG section 'bltouch' option 'z_offset' conflicts with included value Knowledge Base SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value SAVE_CONFIG section ‘extruder’ option ‘pid_Kp’ conflicts with included value Backg…

So how do I correct this. If I try to manually change the z offset in the config I get an error message that it is not valid. It doesn’t recognize the testz command.

I klippy (5).log (1.1 MB) get this Option ‘z_offset’ in section ‘bltouch’ must have minimum of 0.0

TEST_Z only works when running a PROBE_CALIBRATE. This is all explained in the documentation. https://www.klipper3d.org/Probe_Calibrate.html#calibrating-probe-z-offset

when I use PROBE_CALIBRATE, the manual probe window pops up and does nothing. the manual probe doesn’t respond.

if I don’t move the z down and run PROBE_CALIBRATE I get “BLTouch failed to deploy Failed to verify BLTouch probe is raised; retrying.” If I do move it I get the manual probe ??? 5.069 ???

You really need to read the documentation and spend some time to understand it. When you run PROBE_CALIBRATE it will show you the current height the printer believes the nozzle is at as you’ve noted. You then use TESTZ Z=-0.1 to lower the nozzle 0.1mm. You need to lower the nozzle until it just t…

Unknown command:"TESTZ"

General Discussion

Sineos May 20, 2023, 5:47am 3

Topic		Replies	Views
Z_offset not accepted in printer.cfg General Discussion	3	6546	July 5, 2021
Z Offset. Im going CRAZY! General Discussion	17	1563	June 25, 2024
SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value General Discussion	15	736	January 25, 2025
Unable to do Z-Axis Calibration with BL Touch General Discussion	5	826	January 25, 2023
Bad print quality and z-offset not saving General Discussion	20	714	December 17, 2024

Unknown command:"TESTZ"

Related topics