Basic Information:
Printer: Creality K1C
MCU / Printerboard: Stock/Factory
Built-in motherboard
klippy.log attached
Looking for some troubleshooting tips to get WLED working.
I installed it on my old Ender on a rPi and didn’t have any trouble, just followed the guide. Can’t recall if I had to download or install any files. That was well over a year ago.
Now trying to get it to work on my new K1C which I just upgraded to the full version of Klipper. I’ve followed the guides and don’t see any mention of any files/scripts/modules that need to be installed, just the edits to the config files.
The WLED controller is working, it’s on my network, I can access it in my PC browser. My numbered presets all work from there. The lights flash as expected.
Made the changes to moonraker.conf. Have double and triple checked the IP address is correct. Copied over the macros from the Ender that triggered the various presets.
Have checked moonraker and klippy logs for any seemingly related error or status messages (none).
Where do I go from here to continue troubleshooting?
LogsAndConfigs.zip (6.8 MB)
…