I’m trying to set up a 2in1 in klipper using the Cura slicer. The extruders work ok but when I go to print I get this error “extruder” not hot enough can anyone help me solve this problem?
config_2IN1.zip (2.7 KB)
klippy (4).log (253.7 KB)
Hello @cranius223 !
Please stick to the Configs sub-forum purpose!
Hello @EddyMI3D
I don’t understand, could you be clearer or direct me please! Sorry, I’m new here.
When you opened the thread, there was this:
[DELETE_ME_AFTER_READING]
This category is for posting working configs only. It is not intended for support or questions.
[/DELETE_ME_AFTER_READING]
You deleted it right away.
For issues, please use General Discussion.
I moved it for you.
2 Likes
@EddyMI3D. Tks so much!!!
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.