Aquila S3 "Endstop z still triggered after retract"

General Discussion
1

Basic Information:

Printer Model: Aquila S3 by Voxelab
MCU / Printerboard: N32 Mainboard for Aquila X2, Aquila S2 3D printer
klippy.log: klippy.log (181.6 KB)
Printer CFG: printer.cfg (1.6 KB)
Aquila Chip: N32

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

I followed the video as detailed, when i got to auto homing, the X and Y were fine. But when it tried the Z, I got the “Endstop z still triggered after retract” error. I am using the stock auto leveler for the Aquila S3

2

The video I followed

LinkToYoutube

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.