BTT SFS V2 Kraken wiring

General Discussion
1

Basic Information:

Printer Model: Core XY homebrew
MCU / Printerboard: Kraken
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…Hi all wondered if someone would be kind enough to tell me how to wire the SFS V2 sensor to the Kraken board please.

2

As per smart-filament-detection-module/V2.0/Manual/SFS V2.0 User Manual_20231123.pdf at master · bigtreetech/smart-filament-detection-module · GitHub

Using any two free endstop ports on the board

grafik
grafik1163×1082 136 KB

and adapting the pins for the settings according to the chosen ports.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.