Basic Information:
Printer Model: Axion Airwolf
MCU / Printerboard: SKR Mini V3
klippy.log
klippy (8).log (482.8 KB)
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
…Ok Here is my issue and what i have done:
MCU disconnects after first layer on test prints for calibration.
I am currently taking my sons school Axiom Airwolf3d and making it a klipper machine. I have taken out the old board and put in a SKR mini v3, completely designed and printed a new direct drive unit using a e3d V6 clone and extruder with a bl touch.
I have been able to get everything running and have done all the basic calibrations IE PID tune, Acceleration tuning, E-steps/ rotation, and bed mesh.
I have no issue running all the basic step and can also pre-heat nozzle and bed and it will run for like 15 minutes no problem. I then start a print and first layer and skirt come put fine but goes to second layer and get disconnect.
I am using the USB cord that came with the SKR mini and have the connection to the MCU by-path. serial: /dev/serial/by-path/platform-3f980000.usb-usb-0:1.5:1.0
I tried by id but was having issues with it.
I have looked at all the different form post and have not found an answer and don’t know where to look in the klippy log to find answer. i have seen alot of bad usb cables but i have good connection until the printing works.
Looking for any help to have this working for school as it is a $3k machine that does not work.