Basic Information:
Printer Model: Anycubic Mega X
MCU / Printerboard: original from Anycubic
Describe your issue:
Hello I am new to Klipper, I have installed it on Anycubic Mega X with Raspberry pi4 and after some tentatives I got the printer to actually respond and move the proper way.
I am trying to calibrate the printer pressure advance following the guide but I can see that printing the Tower comes out really bad: is this normal? Do I miss something in my configuration file?
The worst corner is the front right although I think is where the printer is trying to hide the seam… But the print itself is really bad…
Any suggestions where I should start troubleshooting from?
I checked all the mechanical of the printer and is good, all belts or bearings spindles are ok.