The printer is not ready on Klipper

[EddyMI3D]

MCU 'mcu' shutdown: ADC out of range

This usually means, there are issues with the thermistors.

Are they connected properly?

You can’t do tests without them.

ADC out of range

ADC out of range Background A thermistor has reported a temperature outside of the specified limits Reasons Specified min_temp / max_temp in the respective heater section has been violated Damaged or faulty thermistor or thermistor cables Potential solutions The error message does not contain the offensive heater. This needs to be analyzed in the klippy.log. Make sure to specify workable limits for min_temp / max_temp for the given heater. They shall reflect sane limits since this is a “…