Basic Information:
Printer Model: sidewinder x1
MCU / Printerboard: Mks gen L
Host / SBC Raspberry Pi 5
klippy.log
klippy (2).log (835.1 KB)
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
I’m using Clanks-Klipper-Configs/SideWinder X1 BLTouch.cfg at master and bltouch waggster mod. My issue, I have duel z motors with belt connecting them. One z stepper motor studders or skips. Not in sink with other z motor. Making loud noise. This started after waggster mod bltouch ver 3.2. Also, bltouch has blinking red light. Not active after homing all axis. I’ve unpluged the z stepper causing noise. All axis home but no active bltouch. I have checked wiring and it seems correct. I would like guidance to fix. Thank you
…